Product Overview
Ram Chuck 3/32 #9601 For Ram Handpieces starting in 2016
** For Handpieces sold starting 2016 and had a serial # starting with 16……, 17……, 18……, etc. – 8 numbers and numbers only
Item # 9601 - 3/32” Chuck For TECH2000, 45000, OPTIMUS, PRIMUS
Item # 9602 – 1/8” Chuck For TECH2000, 45000, OPTIMUS, PRIMUS
** For Handpieces sold prior to 2016 and has a serial # as a mix of numbers and letters - anything that has numbers and letters
Item # T02L-13 - 3/32” Chuck For TECH2000, 45000
Item # T02L-13B – 1/8” Chuck For TECH2000, 45000
Changing collet chucks on most TECH2000, 45000
If you are right-handed hold the lower ½ of the handpiece in your left hand
1 – make sure the blank mandrel or a bur smaller than 1/8” head diameter is inserted in the chuck as this will help support the 3 chuck walls
2 – turn the middle plastic set ring clockwise towards you until it clicks and is in the open position
3 - use the chrome metal chuck wrench tool included in all handpieces and take the wrench and place the triange cut out over the chuck
4 – turn the wrench tool counterclockwise away from you
You should start to feel the chuck unscrewing and it takes about 10m turns to remove the chuck
